Sec. VII. TECHNICAL SPECIFICATIONS
PROCUREMENT OF AUDIO EQUIPMENT

 

Item	Specification
1	2 units DIGITAL MIXER
	• 16 mic/line inputs with high-headroom mic preamplifiers
	• 4 subgroups
	• Stereo/mono main out
	• 6 auxiliary mixes
	• 32-in/18-out FireWire digital recording interface (24 bit/44.1 kHz and 48 kHz)
	• 16 channel strips
	• Trim control with -20 to +20 dBV line/-15 to +65 dBu mic gain range (80dBu)
	• +48V phantom power switch for condenser microphones
	• FireWire Input Select
	• 100 mm precision faders
	• Lighted Solo and Mute buttons
	• Access to Fat Channel functions
	• 15-LED ladder metering + clip LED
	• Analog ¼” insert (rear panel)
	• 4 subgroup buses
	• 6 aux sends
	• 2 internal effects sends:
	• 2 internal digital effects-processors, each with 50 customizable reverb and delay presets
	• Length : 22.35 inches (568.06mm)
	• Width (chassis only): 17.22 inches (437.40 mm)
	• Width (with rack ears): 19 inches (482.60 mm)
	• Maximum Height: 6.90 inches (175.26 mm)
	• Weight: 23 lbs
2	3 units AUDIO PRESS FEED
	• Input Connectors: 2 x Mic/Line XLR Inputs, 1 x Power Input
	• Output Connectors: 8 x Line-Level XLR Outputs, 2 x ¼” Loop-Thru Jacks
	• 1 x 3.5mm Output, 1 x ¼” Headphone Output
	• Power Supply: 117/234VAC, 47-63Hz, 10VA
	• Dimensions (WxHxD): 17 x 1.75 x 10.5” (432 x 44 x 267mm)
	• Weight : 15 lbs (6 kg)
	• Rack Mountable
	• Two mic/line XLR inputs with phantom power and low cut filters
	• Eight transformer-isolated XLR outputs with individual level controls
	• Each output can be set for input A, input B, or a mix of the two
	• A calibrated test tone oscillator can be switched in for either input to perform system tests and level checks
	• Bar graph LED display shows any of the eight outputs or either input
	• Two ¼” jacks in parallel with the XLR inputs provide convenient loop-thru for system expansion
	• Ground-lift switch for minimizing hum
3	15 units DYNAMIC VOCAL MICROPHONE
	• Type : Dynamic (moving coil)
	• Frequency Response: 50 to 15,000 Hz
	• Polar Pattern: Cardioid (unidirectional)
	• Sensitivity (at 1,000 Hz Open Circuit Voltage) -54.5 dBV/Pa (1.85 mV); 1 Pa=94 dB SPL
	• Impedance: Rated impedance is 150 ohms (300 ohms actual) for connection to microphone inputs rated low impedance
	• Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3
	• Connector: Three-pin professional audio connector (male XLR type)
	• Net Weight: 298 grams (10.5 oz)
4	10 units RADIO TRANSCEIVER
	• UHF
	• Minimum Transmission Distance: 10 km range
	• PC or Field programmable
	• 128 memory channels
	• Built-in CTCSS & DCS encoder/decoder
	• Built-in Scrambler
	• Selectable power output
	• FM radio, can store up to 25 radio stations
	• Wide/narrow bandwidth selective
	• Multi-functional keypad
	• Power on password protection
	Lithium-ion Rechargeable battery
	• 53 x 98 x 30 mm compact body
	• Accessories: Flexible Antenna, Li-ion battery pack, charger, adapter, hand strap, belt clip, earphone
5	4 units PROFESSIONAL TABLETOP CD/MP3/USB PLAYER
	• Anti-shock using RAM buffer memory
	• Extra large jog wheel
	• 2 Selectable Jog modes pitch bend/search/scratch
	• Scratch effect mode
	• Multi-function scroll knob for MP3 folder navigation
	• Instant-start & cue with preview
	• Pitch bend via jog wheel or buttons +/-26%
	• Variable pitch control with three setting +/-8, 16 & 24%
	• Frame accurate search
	• Two mode time selection
	• BPM read out (TAP)
	• Seamless loop with reloop
	• Single, Continuous and Repeat play modes
	• CD/MP3/USB Play MP3 files from any USB storage device
6	7 units MINIATURE OMNI-DIRECTIONAL LAVALIER CONDENSER MICROPHONE
	• Transducer : Electret Condenser
	• Polar Pattern: Omni directional
	• Frequency Response: 40 Hz – 20 kHz
	• Dynamic Range (Typical) >90 dB
	• Signal-to-Noise Ratio : 64 dB (@ 1 kHz, 1% THD)
	• Power Requirements: “AA” Battery (1.5v DC), or Phantom Power, 48 v DC
	• Output Impedance: 150 Ohms, (+/-20%, 1 kHz Balanced)
	• Output Connectors: XLR-3M Type
	• Applications: Radio, television and Broadcast
	• Dimensions – Microphone: .5 x .25” (12.5 x 5.6mm) Lx Diameter
	• Power Supply: 5.25 x .82 (131.5 x 20mm) LxW
	• Cable: 10’ x .09” (3m x 2.3mm) LxW
	• Weight – Microphone: 0.053 oz (1.5g) Power Supply: 4 oz (120 g)
	• Weight – Microphone: 0.053 oz (1.5g) Power Supply: 4 oz (120 g)
	• Accessories : Holder clip/s, windscreen, protective carrying case
7	5 units AUDIO PORTABLE MIXER, 10-CHANNEL
	• 4 mic/line inputs, 2 with Class A FET high impedance 60mm professional quality faders
	• Responsive 3-band, swept mid EQ with MusiQ
	• Configurable USB stereo audio in/out
	• 1 pre-fade Aux send
	• 1 FX send
	• 2 stereo inputs
	• Separate 2-track record outputs
	• 16 Internal Effects
	• XLR main stereo outputs with inserts
	• Comprehensive monitoring
	• 48V microphone phantom power
	• DI level switching with Gain Boost
	• Neutrik XLRs and ¼ inch jacks
	• USB : Audio In/Out: USB 1.1 compliant 16-bit; Sample Rate: 32, 44.1, or 48 kHz
	• Dimensions (W x D x H) 13.2 x 13.6 x 3.7” (336 x 346 x 95 mm)
	• Weight : 8.4 lbs (3.8 kg)
8	10 units DYNAMIC HANDHELD MICROPHONE, with microphone holder and windshield w/o ring
	• Transducer : Dynamic
	• Polar Pattern: Super Cardioid
	• Frequency Response : 40 hz – 16 kHz
	• Output Impedance: 250 Ohms
	• Output Connectors : XLR-3M Type
	• Dimensions: 7.87 x 1.92 (199.9 x 48.8mm) Lx Diameter
	• Weight: 8.8 oz (249.34g)
9	1 unit SHOTGUN MICROPHONE with holder & windshield
	• Transducer principle: RF condenser microphone
	• Transducer principle: RF condenser microphone
	• Pick-up pattern: Super cardioid/lobar
	• Frequency Response (microphone) 50 – 20,000 Hz
	• Sensitivity in free field ( 1 khz) 40 (12.5) mV/Pa
	• Nominal impedance: 150Ω
	• Min. terminating impedance: 1,000Ω
	• Equivalent noise level: 8(15) Db
	• Equivalent noise level weighted as per CCIR 468-3: 18 (26) dB
	• Max sound pressure level (passive) 125 (134) dB/1kHz
	• Power supply: 48 ± 4 V Phantom
	• Current consumption: 2 mA
	• Dimensions: d 1 x 11 in (25 x 280mm)
	• Weight : 5.3oz (150g)
10	1 unit 3 SECTION ALUMINUM BOOM POLE
	• Material : Aluminum 13
	• Leg Sections: 3 number
	• Maximum Height: 200.0 cm
	• Minimum Height: 79.0 cm
	• Weight: 0.46 kg
	• Load Capacity: 2 kg
	• Length: 2.59 to 6.56’ (79 to 200 cm)
	• 3 Locking Sections
	• Lightweight Aluminum Construction
	• Anti Leg Rotation System
	• Matt Black Finish
11	10 units DUAL HORIZONTAL MIC HOLDER
	• Custom dual horizontal shock mount
	• Vertical dual mount
	• Heavy-duty black mounting flange
12	8 units AUDIO HEADPHONE
	• Transducer Type: Dynamic neodymium magnet
	• Driver Size: 50 mm
	• Sensitivity (1kHz): 109 dB/mW
	• Impedance (1kHz) : 32Ω
	• Max. Input Power: 3000 mW
	• Frequency Range: 5 Hz – 22 kHz
	• Net Weight (without cable) : 8 oz (235g)
	• Shipping Weight : 24 oz (680 g)
	• Length of Cable: 2 meters (6.56 ft)
	• Type of Cable: Attached, straight oxygen-free copper
	• Plug: Gold-plated 1/8” (3.5mm) stereo mini jack
13	5 units FLOOR STAND MIC HOLDER
	• Minimum Height: 35” (89 cm)
	• Maximum Height: 63” (160 cm)
	• Boom Length: Minimum: 18.1” (46cm), Maximum: 30.1” (76.5 cm)
	• Leg Sections : 3
	• Weight: 7.3 lbs (3.3 kg)
	• Color: Black

********** NOTHING FOLLOWS **********